ESD anti-static access control system_Comprehensive Human Body Tester_Product

ESD anti-static access control system

MP341E Type

Channel type stand-alone anti-static access control system (human body comprehensive electrostatic test access control channel gate) is an advanced product that combines electrostatic testing and channel gate access control; In many places where electrostatic protection zones (EPAs) are set up, the testing of electrostatic footwear and electrostatic wristbands is carried out in a traditional test-only manner, and it is not easy to implement the situation that people who have not passed the test are prohibited from entering the EPA in the first place.

Features:
• Solid-state touch test buttons to keep tests accurate and extend the life of the tester
• 3 sets of high-brightness LED status indicators to indicate high/pass/low resistance of wrist strap, left shoe, and right shoe
• Set the test range with the DIP code, and freely configure the control range of wristbands and electrostatic shoes
• Support single-wire and dual-wire wrist strap measurement, and provide dual interfaces to improve the service life of the plug and dial

Fingerprint wing gate electrostatic access control case

Three-roller turnstile electrostatic access control case

Cargo air shower room access control case

Cargo air shower room access control

No mechanical wear and durability

The test key uses an inner/outer metal conductor, and the test is started by holding down the finger to connect the inner/outer conductor. Solid-state test keys can be used to avoid mechanical damage.

Test scoping setting

The upper limit of the bracelet and the upper and lower limits of anti-static shoes can be set through the DIP switch on the left side of the device according to the control conditions.

ANSI/ESD S20.20-2014 certification requirements
EPA Electrostatic Discharge Protection Zone, Personnel Grounding RequirementsProduct Approval Requirements Limits: Human Shoes Ground System＜1.0×10⁹ohms； Test Method:：ANSI/ESD STM97.1

IEC 61340-5-1-2016 Certification Requirements
EPA Electrostatic Discharge Protection Zone, Personnel Grounding Requirements Approved Requirements Limits: Human Shoes Ground System＜1.0×10⁸ohms； Test Method:：IEC 61340-5-1

Model	MP341
Single-wire wristband measurement	In the tank
Dual-wire wristband measurements	In the tank
Work shoes measured	In the tank
Wristband measurement range	lower limit:750KΩ Maximum: 10MΩ / 35MΩ (optional)
Work shoes measure range	Lower limit: 100KΩ / 750KΩ (optional) Lower limit: 100KΩ / 750KΩ (optional)
Power adapter	100-240V AC to 12V DC/2A
100-240V AC to 12V DC/2A	Approx. 1.5m
Test voltage	9V DC (Open Circuit)
Test accuracy	± 10% or ±20% (when 500M or 1GΩ thresholds are set)
Relay maximum current	1A@30VDC
Operating ambient temperature	5-30°C, 21°C~30°C (when setting 500M or 1GΩ threshold)
Humidity of the working environment	Hamidi Bent Wakin Envi Longment
Test table specifications	160x100x32mm, Weight: 0.3KG
Foot pedal specifications	400x420x35mm，Weight：5.3KG
Net weight	The main body is about 6 kg (without stand)
Warranty	One-year limited warranty