The substrate needs to be de-statized and de-dusted so that the flexible copper foil can better bond with the adhesive and enhance the firmness of the paste. Many customers eliminate static electricity by contacting the material with a de-static brush, which is then grounded through a wire to eliminate static electricity. The disadvantage is that the installation position is limited, need to be replaced often, the effect is not as good as the static electricity elimination stick.

concern：

Wrinkles or unevenness in the copper cladding process, which affects the appearance of the product and results in poor quality.

Solution:

1、the substrate before and after the copper-clad plate were installed Tronovo electrostatic elimination rods.

2、Mounting from the height of the product surface 4~5cm

3、If you need to remove dust, you can connect clean compressed air, and its powerful ionized airflow can remove static electricity and dust foreign matter from the surface.

The installation position of the static eliminator is very critical, the static eliminator is not installed closer to the substrate the better, usually recommended static eliminator distance from the product is about 4 ~ 5cm or so for the better.

Keywords: ESD eliminator, ESD remover, ionic air knife, ionic air knife, ionic rod, industrial static eliminator, ionic air rod, electrostatic removal rod, static eliminator, de-static device for copper-clad plate, de-static equipment for copper-clad plate production, copper-clad plate de-dusting, copper-clad plate electrostatic precipitator, copper-clad plate surface de-static de-dusting machine, copper-clad plate de-static, clean the surface of static electricity of copper-clad plate material, copper-clad plate Surface deduster, static eliminator, static remover, automatic dedusting device for copper-clad laminates.